What is Wet-Abrasive Blasting?
Abrasive media is mixed with water then sent to a nozzle where regulated compressed air is added to adjust the aggressiveness as it discharges over a surface. It is a cost-effect and environmentally safe surface cleaning and preparation method that quickly removes coatings, oxidation, dirt, corrosion, hydrocarbons, auto body cleaning, mold, rust and even graffiti from most surfaces without damaging them.
What results can I expect?
It will remove the toughest coatings, yet is easily adjusted to clean the most fragile surfaces without embedment or damage. From removing corrosion on a battleship to removing graffiti from sandstone, the GEOBLASTER is extremely versatile. Blast with Garnet, crushed glass, soda, olavine, Green Lightening and even sand!
What about the environmental impact?
Our suggested abrasives are environmentally friendly and do not contain any chemicals or chemical by products. Our Environmental Abrasives are non-toxic, which means that after their use, they can be disposed of easily and properly. The GEOBLASTER operates sprays a mixture of abrasive with water vapor, which allows for jubilating to be performed safely indoors, outdoors an within populated urban environments.
How quickly does the GEOBLASTER clean?
After a short set-up time, precise and evenly textured finishes on virtually all surfaces are easily achieved at production rates rivaling sandblasting at a much lower cost.
How costly is the Geo-blaster to operate?
Because cleaning speeds are so quick, and abrasive consumption is minimal (50-200lbs/hr), operating costs are typically a fraction of that of conventional abrasive blasting. Little to no containment is required to protect adjacent buildings, equipment or the general public, saving considerable labor hours by minimizing set-up and clean-up procedures.
Abrasive media is mixed with water then sent to a nozzle where regulated compressed air is added to adjust the aggressiveness as it discharges over a surface. It is a cost-effect and environmentally safe surface cleaning and preparation method that quickly removes coatings, oxidation, dirt, corrosion, hydrocarbons, auto body cleaning, mold, rust and even graffiti from most surfaces without damaging them.
What results can I expect?
It will remove the toughest coatings, yet is easily adjusted to clean the most fragile surfaces without embedment or damage. From removing corrosion on a battleship to removing graffiti from sandstone, the GEOBLASTER is extremely versatile. Blast with Garnet, crushed glass, soda, olavine, Green Lightening and even sand!
What about the environmental impact?
Our suggested abrasives are environmentally friendly and do not contain any chemicals or chemical by products. Our Environmental Abrasives are non-toxic, which means that after their use, they can be disposed of easily and properly. The GEOBLASTER operates sprays a mixture of abrasive with water vapor, which allows for jubilating to be performed safely indoors, outdoors an within populated urban environments.
How quickly does the GEOBLASTER clean?
After a short set-up time, precise and evenly textured finishes on virtually all surfaces are easily achieved at production rates rivaling sandblasting at a much lower cost.
How costly is the Geo-blaster to operate?
Because cleaning speeds are so quick, and abrasive consumption is minimal (50-200lbs/hr), operating costs are typically a fraction of that of conventional abrasive blasting. Little to no containment is required to protect adjacent buildings, equipment or the general public, saving considerable labor hours by minimizing set-up and clean-up procedures.
